White Skyline Towing Ram 1500 roadside service pickup parked in a residential driveway next to a white Saturn sedan

How to Jump Start a Car: Step-by-Step Jumper Cable Guide

To jump start a car with jumper cables: connect red to the dead battery’s positive terminal, red to the good battery’s positive, black to the good battery’s negative, and the last black clamp to bare metal on the dead car away from the battery. Start the good car, wait a few minutes, then start the dead one. Remove the cables in reverse order. Always check your owner’s manual first, because many newer cars have specific jump points.

Before you start

  • Park the cars close without touching. Both in park (or neutral for a manual) with the parking brake on.
  • Turn off both ignitions, headlights and accessories.
  • Look at the dead battery. If it’s cracked, leaking, bulging or smells like rotten eggs, don’t jump it. Call for help.
  • If the battery is frozen solid, don’t jump it.
  • Find the positive (+, usually red cover) and negative (-) terminals or the jump posts your manual shows.

Step by step

  1. Clamp one red cable end to the dead battery’s positive terminal.
  2. Clamp the other red end to the good battery’s positive terminal.
  3. Clamp one black end to the good battery’s negative terminal.
  4. Clamp the last black end to unpainted metal on the dead car’s engine or frame, away from the battery and moving parts. This is the ground.
  5. Start the good car and let it run for a few minutes.
  6. Try starting the dead car. If it doesn’t start, wait a few more minutes and try again. Don’t crank for more than several seconds at a time.
  7. Once it starts, remove the cables in reverse order: black from the ground, black from the good battery, red from the good battery, red from the formerly dead battery. Don’t let the clamps touch each other.

Using a portable jump pack

Charge the pack ahead of time. With the car off, connect red to positive and black to a ground point (or negative, if the pack’s instructions say so), turn the pack on, and start the car. Turn the pack off before removing the clamps.

After the jump

Drive at least 20 to 30 minutes so the alternator can recharge the battery. If the battery is more than a few years old or this keeps happening, have it tested. Many auto parts stores test batteries for free.

If it still won’t start

  • Clicking with no crank, even when connected: could be a bad connection, the starter, or a battery too far gone.
  • Cranks normally but won’t start: probably not the battery. Fuel, ignition or sensors may be the issue.
  • Starts, then dies right away: possibly the alternator.

At that point, stop cranking and call for help. See what to do with a dead car battery.

Hybrids and EVs

Hybrids and EVs have a 12-volt battery that can be jumped, but often only from specific points, and some shouldn’t be used to jump other cars. Follow the manual and never touch the high-voltage system.

No cables? No problem

Skyline Towing does jump starts across Metro Detroit: $100 in Wayne County, $125 in Oakland County. Call (248) 832-6000 or see our jump start service guide.

Skyline Towing, 6450 E Hancock St, Detroit, MI 48207. (248) 832-6000.

Leave a Comment

Your email address will not be published. Required fields are marked *